1. Cut a length of beading wire that is twice the desired length of your phone chain plus an extra inch.
2. String on a bead cap, followed by approximately 20 beads. Add another bead cap, and then thread the wire back through the first few beads.
This will create a small loop at one end of the strand.
3. Continue stringing beads until the strand is the desired length. To finish, create another small loop at the other end of the strand in the same manner as step 2.
4. Use pliers to gently twist each loop closed. Trim any excess wire, and enjoy your new beaded phone chain!
- Cut a piece of string or fishing line to be about twice the length of your desired phone chain
- String on one bead, then tie a knot right next to the bead
- String on another bead and tie another knot right next to it
- Repeat this process until you have reached your desired length
- Once you have reached your desired length, take both ends of the string and tie them together in a double knot, making sure that all the beads are snug against each other
- Trim any excess string and voila! You now have a beautiful beaded phone chain
HOW TO MAKE TRENDY DIY PHONE CHARMS!
How to Tie a Phone Charm
Assuming you would like a step-by-step guide on how to tie a phone charm:
You will need:
-A phone charm (this can be anything from a keychain to an actual charm)
-A length of string, ribbon, or cord
1.Thread the string through the loop at the top of the charm. If your charm doesn’t have a loop, create one by threading the string through itself and pulling tight.
2.Tie a knot in the end of the string to secure it in place.
3.Wrap the string around your phone so that the charm hangs where you want it. Cross the string over itself and tie another knot to secure it in place.
Trim any excess string.
Credit: www.youtube.com
How Do You Put a Bead on a Phone Chain?
If you want to add a bead to a phone chain, there are a few things you’ll need to do. First, thread the bead onto the wire. Make sure that the bead is small enough to fit through the hole in the phone chain.
Next, use needle nose pliers to bend the wire around the bead. You’ll want to make sure that the wire is tight so that the bead doesn’t fall off. Finally, use your fingers or a pair of pliers to twist the two ends of the wire together.
What Thread to Use for Phone Charm?
When it comes to phone charms, there are a few different types of thread that can be used. Each type of thread has its own benefits and drawbacks, so it’s important to choose the right one for your project.
The most common type of thread for phone charms is nylon.
Nylon is strong and resistant to stretching, making it ideal for holding together beads and other small components. It’s also relatively inexpensive, which makes it a good choice for large projects. However, nylon can be tricky to work with if you’re not familiar with it, as it tends to fray easily.
Another popular option is polyester thread. Polyester is similar to nylon in terms of strength and stretch resistance, but it’s slightly more expensive. It’s also less likely to fray than nylon, making it easier to work with.
However, polyester can be difficult to sew through because of its slippery texture.
Finally, there is cotton thread. Cotton is the weakest of the three options, but it’s also the most affordable.
Conclusion
This post has given some great tips on how to make a beaded phone chain. By following the steps listed, you can easily create your own chain to keep your phone safe and stylish. With a little bit of creativity, you can even personalize your chain to match your personality.
So get creative and have fun!
